Restrictions to existing 3D wheel aligners
It is common knowledge that when installing any 3D wheel aligner there are some restrictions on the distance to the front wall. Because of this a 3D wheel aligner installation sometimes becomes impossible.
Technocar�s new product � Techno Vector 6 – has been designed to remove these restrictions and allow owners of small workshops to use 3D technology! !
The camera sees measurement targets located on the front wheels and reference targets simultaneously. Camera and target coordinates in space are calculated. These data are used to calculate wheel alignment angles.
As all the measurement system is within the sizes of the lift and is raised and lowered together with the vehicle, adjustment can be performed at any height; posts of the lift do not overlap camera vision range.
Wheel aligner installation
Techno Vector 6 does not require assembly work. The wheel aligner is not attached to a certain lift or a workplace. It is enough just to move the shaft with reference targets, measurement targets and portable camera units � and your wheel aligner is ready to work at a new place.
Disc runout compensation
Disc runout compensation can be performed by rolling the vehicle. It is enough to roll the vehicle by ~ 40cm to perform this procedure.
Techno Vectro 6 wheel aligner is ideal for both big car service centers and small garages that want to use up-to-date 3D wheel aligners even in a small workshop.